Port) interface configuration – Comtrol ES9528-XT User Guide User Manual

Page 135

Advertising
background image

RocketLinx ES9528 and ES9528-XT User Guide: 2000508 Rev. G

(Port) Interface Configuration - 135

Configuration Using the Command Line Interface (CLI)

(Port) Interface Configuration

When you type interface IFNAME in Global Configuration mode, you can access Interface Configuration mode.
In this mode you can configure port settings.

The port interface names for the Fast Ethernet ports are fa1 through fa28

Type the following commands and press the Enter key:

exit to return to Privileged EXEC mode.

? to see the command list.

list to review the Interface Configuration mode commands and corresponding options. The following list is
the available commands for the Port Interface Configuration mode.

For the complete list of commands and options, refer to

Port Interface Configuration Mode

on Page 198.

Switch(config)# interface fa1

Switch(config-if)#

acceptable Configure 802.1Q acceptable frame types of a port

auto-negotiation Enable auto-negotiation state of a given port

description Interface specific description

dot1x IEEE 802.1x standard access security control

duplex Specify duplex mode of operation for a port

end End current mode and change to enable mode

ethertype Ethertype

exit Exit current mode and down to previous mode

flowcontrol Set flow-control value for an interface

garp General Attribute Registration Protocol

ingress IEEE 802.1Q ingress filtering features

ip Interface Internet Protocol config commands

lacp Link Aggregation Control Protocol

list Print command list

loopback Specify loopback mode of operation for a port

mac MAC interface commands

mdix Enable mdix state of a given port

no Negate a command or set its defaults

qos Quality of Service (QoS)

quit Exit current mode and down to previous mode

rate-limit Rate limit configuration

shutdown Shutdown the selected interface

spanning-tree spanning-tree protocol

speed Specify the speed of a Fast Ethernet port or a

Gigabit Ethernet port

storm-control Enables packet flooding rate limiting features

switchport Set switching mode characteristics

Advertising
This manual is related to the following products: