Comtrol ES9528-XT User Guide - Manual (Page 146)

146 - Port Configuration (CLI) RocketLinx ES9528 and ES9528-XT User Guide: 2000508 Rev. G
Configuration Using the Command Line Interface (CLI)
Rate Control
Rate Control –
Ingress or Egress
Switch(config-if)# rate-limit
egress Outgoing packets
ingress Incoming packets
Note: To enable rate control, you should select the Ingress or Egress rule first; then
assign the packet type and bandwidth.
Rate Control -
Bandwidth
Switch(config-if)# rate-limit ingress bandwidth
<0-1000000> Limit in kilobits per second (FE: 0-100000, GE: 0-
1000000, 0 is no limit)
Switch(config-if)# rate-limit ingress bandwidth 800
Set the ingress rate limit 800Kbps for Port 1..
Storm Control
Storm Control –
Packet Type
Switch(config-if)# storm-control
broadcast Broadcast packets
dlf Destination Lookup Failure
multicast Multicast packets
Storm Control -
Rate
Switch(config)# storm-control broadcast
<0-100000> Rate limit value 0~100000Kbyte/sec
Switch(config)# storm-control broadcast 10000
limit_rate = 10000
Set rate limit for Broadcast packets.
Switch(config)# storm-control multicast 10000
limit_rate = 10000
Set rate limit for Multicast packets.
Switch(config)# storm-control dlf 10000
limit_rate = 10000
Set rate limit for Destination Lookup Failure packets.
Port Trunking
LACP
Switch(config)# lacp group 1 gi8-10
Group 1 based on LACP(IEEE 802.3ad) is enabled!
Note: The interface list is fa1,fa3-5, gi8-10 and a different speed port can’t be
aggregated together.
Static Trunk
Switch(config)# trunk group 2 fa6-7
Trunk group 2 enable ok!
Display - LACP
ES9528# show lacp internal
LACP group 1 internal information:
LACP Port Admin Oper Port
Port Priority Key Key State
----- ----------- -------- -------- -------
8 1 8 8 0x45
9 1 9 9 0x45
10 1 10 10 0x45
LACP group 2 is inactive
LACP group 3 is inactive
LACP group 4 is inactive