Comtrol ES9528-XT User Guide - Manual (Page 176)

176 - Warnings (CLI) RocketLinx ES9528 and ES9528-XT User Guide: 2000508 Rev. G
Configuration Using the Command Line Interface (CLI)
Warnings (CLI)
The ES9528 provides several types of warning features for you to remotely monitor the status of the attached
devices or changes in your network. The features include System Log and SMTP Email Alert.
Optionally, you can use the web user interface for configuration, see Warning on Page 113.
This table provides detailed information about the command lines of the warning configuration.
Event Selection
Event Selection
Switch(config)# warning-event
coldstart Switch cold start event
warmstart Switch warm start event
linkdown Switch link down event
linkup Switch link up event
authentication Authentication failure event
super-ring Switch super ring topology change event
time-sync Switch time synchronize event
Example:
Cold Start event
Switch(config)# warning-event coldstart
Set cold start event enable ok.
Example:
Link Up event
Switch(config)# warning-event linkup
[IFNAME] Interface list, ex: fa1,fa3-5,gi25-28
Switch(config)# warning-event linkup fa1gi2
Set fa5 link up event enable ok.
Display
Switch# show warning-event
Warning Event:
Cold Start: Enabled
Warm Start: Disabled
Authentication Failure: Disabled
Link Down: fa4-5
Link Up: fa4-5
Power Failure:
Super Ring Topology Change: Disabled
Fault Relay: Disabled
Time synchronize Failure: Disabled