Comtrol ES9528-XT User Guide - Manual (Page 60)

60 - Restore the Configuration - TFTP Server Method RocketLinx ES9528 and ES9528-XT User Guide: 2000508 Rev. G
Configuration Using the Web Interface
Restore the Configuration - TFTP Server Method
To restore a configuration file, you must open a TFTP server. If necessary, use Start the TFTP Server on Page
59.
The backup file must be located in the same directory that the TFTP server resides for this procedure to work.
1. Open the web user interface for the ES9528, open the Backup and Restore page under Basic Settings.
2. Select TFTP Server for the Restore Configuration, enter the IP
address of the TFTP server, enter the Backup File Name, and
click the Restore button.
3. Click Yes to the Confirm Dialog message.
4. Click Ok to the Success Message.
Firmware Upgrade
Use this section to update the ES9528 with the latest firmware. Comtrol provides the latest firmware on the
Comtrol
FTP site . Updated firmware may include new features, bug fixes, or other software changes. Comtrol
Technical Support suggests you use the latest firmware before installing the ES9528 at a customer site.
Note: Optionally, you can use PortVision DX to upload the latest firmware. If you need to upload a new
version of the Bootloader, you must use PortVision DX or the CLI. You cannot use the web user interface
to upload the Bootloader.
Note: The system is automatically rebooted after you finish upgrading firmware. You should alert the
attached users before updating the firmware that network interruption may occur.
Firmware Upgrade Page
System Firmware
Version
The firmware version on the ES9528.
You should check the version number after the switch reboots.
System Firmware
Date
The build date of the firmware on the ES9528.
Firmware Upgrade
• Local File - see Upgrading Firmware (Local File) on Page 61
• TFTP Server - see Upgrading Firmware (TFTP Server) on Page 62