Comtrol ES9528-XT User Guide - Manual (Page 181)

RocketLinx ES9528 and ES9528-XT User Guide: 2000508 Rev. G Saving to Flash (CLI) - 181
Configuration Using the Command Line Interface (CLI)
Saving to Flash (CLI)
Save Configuration allows you to save any configuration you just made to the flash. Powering off the switch
without saving the configuration causes loss of the new settings.
Logging Out (CLI)
The CLI connection logs out of configure terminal mode, if you do not input any command after 30 seconds.
Service (CLI)
The service command provides the ability to disable HTTP and Telnet.
Note: There is not a web user interface page for the service command.
Saving to Flash
Save to Flash
SWITCH# write
Building Configuration…
[OK]
Switch# copy running-config startup-config
Building Configuration...
[OK]
Logging Out
Logout SWITCH> exit
SWITCH# exit
Service
Disable HTTP
Switch(config)# service http disable
Switch(config)#
Enable HTTP
Switch(config)# service http enable
Switch(config)#
Disable telnet
Switch(config)# service telnet disable
Switch(config)#
Enable telnet
Switch(config)# service telnet enable
Switch(config)#