Futaba 4PL 2.4GHz FHSS - Manual (Page 14)

14
B
e
for
e
Using
After opening the box, first check if the contents conform to the following. The contents
depend on the set as shown below.
Set Contents
Transmitter T4PL
Receiver R2104GF
Miscellaneous
Dry battery holder
*Installed in transmitter.
Receiver switch
Mini screwdriver
* It is used for R2104GF.
Instruction manual
- If any of the set contents are missing, or you have any questions, please contact
your dealer.
ｎ Caution
ｊ When using the T4PL in the high speed (HIGH) mode, always use it under the following condi-
tions:
Servos :Futaba digital servo (including BLS Series brushless servos)
Receiver’s battery :Matched to the ratings of the receiver and connected digital servo (dry cell battery cannot be used).
Transmitter mode :"HIGH" mode (See page 42 for setting method.)
Under other conditions, the set will not operate, or the specified performance will not be displayed even if it operates.
In addition, it may cause servo trouble. Futaba will not be responsible for damage, etc. caused by combination with the
products of other companies.
In addition, the FSU Fail Safe Unit cannot be used because the system is different. Use the fail safe function of the
transmitter.
ｊ When using analog servos, always switch the T4PL servo response to the "NORM" mode.
Transmitter mode :"NORM" mode (See page 42 for setting method.)
Receiver’s battery :Matched to the ratings of the receiver and connected digital servo (dry cell battery cannot be used).
The set cannot operate in the "HIGH" mode. Operation in this mode will cause trouble with the servos and other equipment.
Digital servos (including BLS Series brushless servos) can also be used in the "NORM" mode.
ｊ Always use only genuine Futaba transmitters, receivers, servos, ESCs (electronic speed con-
trols), NiMH, NiCd, Li-ion batteries and other optional accessories.
Futaba will not be responsible for problems caused by the use of other than Futaba genuine parts. Use the parts speci-
fied in the instruction manual and catalog.