Futaba 4PL 2.4GHz FHSS - Manual (Page 65)

65
Fu
n
c
tio
n
Advance Menu "ADVANCE"
Program mixing PRG MIX
Mixing can be applied between the steering, throttle, channel 3, and channel 4 chan-
nels.
A.B.S function [ABS]
Pumping brake operation, which brakes the throttle servo intermittently at brake op-
eration, can be set.
Brake mixing [BRAKE MIX]
This function is used when the front and rear brakes are independent and are adjusted
individually such as a 1/5GP car.
4WS mixing [4WS MIX]
This function can be used with crawlers and other 4WS type vehicles. It is mixing
which controls front side steering by CH1 and rear side steering by CH3.
Dual ESC [DUAL ESC]
This function is mixing used when the front and rear drive motor controllers of a
crawler or similar vehicle are used independently.
Throttle mode [THR MODE]
This menu contains the following throttle functions:
SXNT (Neutral position)
The forward and brake (back) operation ratio can be selected from 7:3 and 5:5 by
changing the neutral position of the throttle servo.
IDLUP (Idle up)
This function is used to improve engine starting performance by raising the idling
speed when the engine of a gasoline car (boat) is started.
NTBRK (Neutral brake)
The neutral brake position, which applies the brakes at the neutral position of the
trigger, can be set.
THOFF (Throttle off)
This function stops the engine of a boat, etc. by operating the throttle servo to the
set position by switch regardless of the throttle trigger position.
Function trim dial/switch [DIAL SW]
Refer to the function trim dial and function switch described on P60 to P63.
MC link [MC LINK]
This is a special function which allows Futaba motor controller (MC) data changes to
be set by the T4PL transmitter (MC950CR, MC851C, MC602C, MC02R, etc.).