Futaba 4PL 2.4GHz FHSS - Manual (Page 48)

(HOME screen)
100
48
Fu
n
c
tio
n
End Point Adjuster "EPA"
(Preparation)
- Display the THROTTLE 1 menus to be set.
- Before setting the throttle end point adjustment(EPA), set the
throttle ATL lever (initial setup: DT4) to the maximum throttle
angle position 100%.
- Select the setting item "EPA-F" by (UP) or (DN) button.
1
Throttle (forward side) adjustment
Pull the throttle trigger fully to the high side and use
the (+) or (-) buttons to adjust the throttle angle.
However, when using an FET amp, set to 100%.
2
Throttle (brake side/reverse side) adjustment
Move the throttle trigger fully to the brake side and
use the (+) or (-) buttons to adjust the throttle angle.
However, when using an ESC, set to 100%.
3
When ending, return to the menu screen by pressing the (CT)
button.
Throttle (EPA) adjustment
(Preparation)
- Refer to P44 and display the channel 3 or channel 4 menu and
make the following adjustments:
1
3rd/4th channel servo (up side) adjustment
Select the setting item "EPA-U" by (UP) or (DN) button, and
set the 3rd or 4th channel dial fully to the up side (+ side)
and use the (+) or (-) buttons to adjust the servo angle.
2
3rd/4th channel servo (down side) adjustment
Select the setting item "EPA-D" by (UP) or (DN) button, and
set the 3rd or 4th channel dial fully to the down side (- side)
and use the (+) or (-) buttons to adjust the servo angle.
3
When ending, return to the menu screen by pressing the (CT)
button.
3rd & 4th channel servo (EPA) adjustment
Adjust button
- Use the (+) and (-) buttons to
make adjustments.
- Return to the initial value "100"
by pressing the (+) and (-) but-
tons simultaneously for about 1
second.
Throttle EPA
EPA-F
:0~120
EPA-B :0~120
Initial value :100
Adjust button
Adjust with the (+) and (-) but-
tons.
- Return to the initial value "100"
by pressing the (+) and (-) but-
tons simultaneously for about 1
second.
3rd & 4th channel EPA
EPA-U
:0~120
EPA-D :0~120
Initial value :100