Futaba 4PL 2.4GHz FHSS - Manual (Page 89)

Alarm time (ALRM)
OFF, 1 ~ 99 m
Initial value: 5 m
Status display
RST :Reset state
RDY :Throttle trigger operation wait
RUN :Timer running
STP :
Timer stopped
Status display
RST :Reset state
RDY :Throttle trigger operation wait
RUN :Timer running
STP :
Timer stopped
89
Fu
n
c
tio
n
Timer Function "TIMER"
(Preparation)
Select the setting item "TYPE" by (UP) or (DN) button.
Press the (+) or (-) button and select "UP".
1
(Alarm time setting)
Select the setting item "ALRM" by (UP) or (DN)
button and set the alarm time with the (+) or (-)
button.
2
(Timer start/stop operation)
Start the timer by pressing the switch ("TIMER") set by func-
tion select switch function.
Stop the timer with the same switch ("TIMER") as start.
- Linking only start to the throttle trigger
Select the setting item "RST" by (UP) or (DN)
button and press the (+) and (-) buttons simul-
taneously for approximately 1 second. When
the set beeps and the status display switches
from "RST" to blinking "RDY", the system en-
ters the trigger operation ready state. When
the trigger is operated at the forward side, the
timer starts. (Status display "RUN")
If the (CT) button is pressed while the timer is operating, the
LCD returns to HOME screen.
3
(Timer reset operation)
Select a status display ("RUN", "STP", or "RDY") by (UP) or
(DN) button and press the (+) and (-) buttons
simultaneously for approximately 1 second. A
beep is generated and "RST" appears on the
status display and the timer resets.
Using the up timer
Adjustment buttons
- Use the (+) and (-) buttons to
make adjustments.
- Press the (+) and (-) buttons
simultaneously (approx. 1 sec)
to return to the HOME screen.
Switches
Time start / stop