Fu n c tio n – Futaba 4PL 2.4GHz FHSS User Manual
Page 69
AB.P
(Amount of brake return)
AB.P
Ser
v
o
tr
a
v
el
69
Fu
n
c
tio
n
A.B.S Function "A.B.S"
- DELY : Delay
Sets the delay from brake operation to ABS operation. When set to 0%, the ABS func-
tion is activated without any delay. At 50%, the ABS function is activated after a delay
of approximately 1 second and at 100%, the ABS function is activated after a delay of
approximately 2 seconds.
- CYCL : Cycle speed
Sets the pulse speed (cycle). The smaller the set value, the faster the pulse cycle.
- TG.P : Trigger point
Sets the trigger point at which the ABS function begins to operate at brake operation.
- DUTY : Cycle duty ratio
Sets the proportion of the time the brakes are applied and the time the brakes are re-
leased by pulse operation. The ratio can be set to HIGH, MID or LOW.
- MODE : Function ON/OFF
ABS function ON/OFF setting. When using the ABS function, set to "ACT(ON)".
1
(Function ON/OFF)
Select the setting item "MODE" by (UP) or (DN) button.
Set the function to the active state by pressing the (+) or (-)
button.
"INH(OFF)" :Function
OFF
"ACT(ON)" :Function
ON
"ACT(OFF)"
:Switch OFF when setting switches
2
(Brake return amount adjustment)
Select the setting item "AB.P"
by (UP) or (DN) button. Use
the (+) or (-) button to adjust
the return amount.
"0" :No
return
"50"
:Return to the 50% position of the brake operation amount
"100"
:Return to the neutral position.
3
(Delay amount setup)
Select the setting item "DELY" by (UP) or (DN) button.
Use the (+) or (-) button to adjust the delay amount.
"0"
:A.B.S. function performed without any delay
"50"
:A.B.S function performed after an approximate 1 sec delay.
"100"
:A.B.S. function performed after an approximate 2 secs delay.
A.B.S function adjustment
- Brake return amount (AB.P) is
influenced by the "EXP" rate
on the brake side.
Delay amount (DELY)
0 ~ 100
Initial value: 0
Adjustment buttons
- Use the (+) and (-) buttons to
make adjustments.
- Return to the initial value by
pressing the (+) and (-) buttons
simultaneously (approx. 1 sec).
Brake return amount (AB.P)
0 ~ 50 ~ 100
Initial value: 50
Function ON/OFF (MODE)
INH(OFF), ACT(ON), ACT(OFF)
Setup item selection
- Select by by (UP) or (DN) but-
ton.