Futaba 4PL 2.4GHz FHSS - Manual (Page 75)

75
Fu
n
c
tio
n
4WS Mixes 4WS) "4WS-MIX"
(Preparation)
Since this function is used by switching the type of 4WS with
a switch, the switch used by the function select switch func-
tion (page 62) is set.
1
(4WS type selection)
Operate the (UP) or (DN) button, and select the setting item
"MODE". Select the type by pressing the (+) or (-) button.
"INH" :Function OFF (front only)
"2TYP" :Front side only, reverse phase switching
"3TYP" :Front side only, reverse phase and same phase switching
"4TYP" :Front side only, reverse phase, same phase, and rear side only switching
4WS mixing adjustment
Switched in the order shown in the figure below by set SW
2
(Rear side travel adjustment)
Select setting item "RATE" by (UP) or (DN) button. Adjust the
rear side travel with the (+) or (-) button.
3
(Mix mode setting)
Select setting item "MXMD" by (UP) or (DN) button.Set the
mix mode with the (+) or (-) button.
"OFF" :The EXP function of the 1st CH and other settings are not mixed.
"ON" :The EXP function o the 1st CH and other settings are mixed.
4
When ending, return to the ADVANCE menu screen by
pressing the (CT) button.
Function ON/OFF (MODE)
OFF, 2TYP, 3TYP, 4TYP
Mixing mode (MXMD)
OFF, ON
Initial value: OFF
Rear rate (RATE)
0 ~ 100
Initial value:100
"2TYP" Front side only and reverse phase switching "3TYP" Front side only, reverse phase, and same phase switching
"4TYP" Front side only, reverse phase, same phase, and rear side only switching
Setup buttons
- Use the (+) and (-) buttons to
make adjustments.
Adjustment buttons
- Use the (+) and (-) buttons to
make adjustments.
- Return to the initial value by
pressing the (+) and (-) buttons
simultaneously (approx. 1 sec).