Futaba 4PL 2.4GHz FHSS - Manual (Page 24)

ｎ WARNING
ｎ Caution
Antenna
tube
Antenna
Coaxial
cable
R2104GF
24
B
e
for
e
Using
ｊ Always use R2104GF under the following conditions:
Battery :Power requirement Rated voltage 4.8~7.4V (dry cell battery cannot be used) / 3.5 to 8.4V useable
Matched to the ratings of the receiver and connected servo.
RX Type :"SFH" or "FH" (See p.42 for setting method.)
Transmitter mode-"HIGH" mode :Futaba digital servo (See p.42 for setting method.)
Transmitter mode-"NORM" mode :Futaba all servo (See p.42 for setting method.)
Under other conditions, the set will not operate, or the specified performance will not be displayed even if it operates. In
addition, it may cause trouble with servos and other equipment. Futaba will not be responsible for damage, etc. caused
by combination with the products of other companies.
Receiver Installation
Install the R2104GF receiver on the car as follows:
The operating range may become shorter, depending on where the receiver and the an-
tenna are mounted.
ｌ Do not cut or bundle the receiver antenna wire.
ｌ Do not bend the coaxial cable. It causes damage.
ｊ Install the antenna in the higher place as shown in the figure.
ｊ Put the antenna in the antenna tube to protect it.
Transmitter mode setting
Set the transmitter to the "HIGH" mode or "NORM" mode. See page 42 for a description of the
setting method.
Note: However, digital servos (including BLS Series brushless servo) can only be used in the HIGH mode.
When the power is turned on, whether the receiver is in the HIGH or NORM mode the R2104GF operates in that mode until
the power is turned off. When the transmitter mode is changed, operation becomes possible when the receiver power is turned on
again.
ｊ Keep the antenna as far away from the motor, ESC and other
noise sources as you possibly can.
ｊ Wrap the receiver with something soft, such as foam rubber, to
avoid vibration. If there is a chance of getting wet, put the receiver
in a waterproof bag or balloon.