Futaba 4PL 2.4GHz FHSS - Manual (Page 82)

Communication port
ESC receiver connector
Connecting ESC receiver
connector to the transmitter
Communication port
Connection diagram
MC LINK screen Example: MC402CR
82
Fu
n
c
tio
n
(Preparation)
-Connect the T4PL and ESC in accordance with the connec-
tion diagram, and connect the battery to ESC.
1
Set the transmitter power switch to the display side (DISP).
Display the MC LINK function screen as described on P64.
2
(ESC read)
Execute this function to read the connected ESC type and
the data currently set at the amp. To save the ESC data to
the T4PL, rewrite the read data.
When you want to write the data saved in the T4PL to an
ESC of the same type, execute the following "WRITE"(write)
without executing "READ"(read).
Using the ESC Link function
When "MC-LINK" menu is
selected when the trans-
mitter power switch is at
the transmit side (PWR
ON) the message shown
below prompting you to set
the switch to the display
side is displayed.
ESC Link Function "MC LINK"
This is a special function which lets you set the contents of the Link software
which performs Futaba speed controller (ESC), MC950CR, MC851C, MC602C,
MC402CR, etc. variable frequency and other data changes at the T4PL transmit-
ter. However, some data changes require a PC and Link software. This function is
used by connecting ESC directly to the transmitter. The T4PL power switch is used
at the display side. Use the various optional servo extension cords according to the
distance between the transmitter and ESC. The last data read from ESC to T4PL or
the last data written from T4PL to ESC is saved to the T4PL. Since the data for each
model memory can be saved, the data of up to 40 models can be saved.
-When the T4PL battery voltage drops, the display switches to low battery display. Therefore, use this function when there is
ample battery capacity remaining.
-Also connect the battery at the ESC side.
ESC Link Function "MCLNK"