Futaba 4PL 2.4GHz FHSS - Manual (Page 90)

Alarm time (ALRM)
OFF, 1 ~ 99 m
Initial value: 5 m
Status display
RST :Reset state
RDY :Throttle trigger operation wait
RUN :Timer running
Status display
RST :Reset state
RDY :Throttle trigger operation wait
RUN :Timer running
90
Fu
n
c
tio
n
Timer Function "TIMER"
(Preparation)
Select the setting item "TYPE" by (UP) or (DN) button.
Press the (+) or (-) button and select "DOWN".
1
(Alarm time setting)
Select the setting item "ALRM" by (UP) or (DN)
button and set the alarm time with the (+) or (-)
button.
2
(Alarm start/restart operation)
When the switch ("TIMER") set by function select switch
function is pressed, the timer starts. When the same switch
("TIMER") is pressed while the timer is operating, the timer is
reset and simultaneously restarted. (Restart)
- Linking only start to the throttle trigger
Select the setting item "RST" by (UP) or (DN)
button and press the (+) and (-) buttons simul-
taneously for about 1 second. When the set
beeps and the status display switches from
"RST" to blinking "RDY", the system enters
the trigger operation ready state. When the
trigger is operated at the forward side, the
timer starts. (Status display "RUN")
If the (CT) button is pressed while the timer is operating, the
LCD returns to the HOME screen.
3
(Timer reset operation)
Select a status display ("RUN") by (UP) or (DN)
button and press the (+) and (-) buttons simul-
taneously for approximately 1 second. A beep-
ing sound is generated and "RST" appears on
the status display and the timer resets.
Using the fuel down timer
Adjustment buttons
- Use the (+) and (-) buttons to
make adjustments.
- Press the (+) and (-) buttons
simultaneously (approx. 1 sec)
to return to the HOME screen.
Switches
Timer start / restart