Futaba 4PL 2.4GHz FHSS - Manual (Page 98)

98
Fu
n
c
tio
n
Adjuster "ADJUSTER"
3
When ending setting, return to the ADJUSTER screen by
pressing the (CT) button. When *SYSTEM is selected from
the ADJUSTER screen and the (CT) button is pressed, the
LCD returns to the system screen and if <HOME> is se-
lected and the (CT) button is pressed, the LCD returns to the
HOME screen.
(Preparation)
-On the system menu screen, select the ADJUSTER screen
by selecting "*ADJUSTER" by (UP) or (DN) button and
pressing the (CT) button.
-In the state in which "TRIGGER" (throttle side) is selected
by (UP) or (DN) button, display the ADJUSTER screen by
pressing the (CT) button.
1
(Throttle neutral adjustment)
In the neutral setup screen state (figure at the right), lightly
pull the throttle trigger in the forward direction and press the
(+) and (-) buttons simultaneously in the state in which the
trigger is not touched.
2
(Throttle throw adjustment)
In the throw setup screen state (figure at the right), lightly op-
erate the trigger fully to the brake side and the forward side
and when PUSH +/- is displayed press the (+) and (-) buttons
simultaneously.
Internal check is performed automatically. When each adjust-
ment point is within a fixed range, correction is performed
and "COMPLETE!" (figure at the right) is displayed.
If an adjustment point is not within a fixed range, correction
is not performed and the correction data is not updated.
When PUSH +/- is not displayed even though correction was
performed again, please contact a Futaba Radio Control
Customer Center.
3
When ending setting, return to the ADJUSTER screen by
pressing the (CT) button. When *SYSTEM is selected from
the ADJUSTER screen and the (CT) button is pressed, the
LCD returns to the system screen and when <HOME>is se-
lected and the (CT) button is pressed, the LCD returns to the
HOME screen.
Throttle adjustment