Futaba 4PL 2.4GHz FHSS - Manual (Page 41)

Move the cursor to EXEC: and
press the (+) and (-) buttons si-
multaneously for approximately
1 second.
"OK!" is displayed.
Move the cursor to MODE and
select "RESET" with the (+) or
(-) button.
41
Fu
n
c
tio
n
Model / Receiver Type / Servo Response Mode "MODEL RX"
Using the model reset function
Model Reset "RESET"
This function resets and initializes the contents of the currently selected model data.
However, the adjuster function (ADJUSTER), system setting (SYSTEM), and type of
receiver mode (TYPE)/servo response (RESP) are not initialized.
- Display the MODEL RX menu by referring to P38.
1
(Selection of model reset)
Move the cursor to MODE by (UP) or (DN)
button and select "RESET" with the (+) or (-)
button.
When the receiver type and servo response (FH, SFH or HIGH, NORM) were
changed on the MODEL RX menu screen, the change is not complete until the
power is turned on again. When receiver type or servo response change followed
by model reset were executed while the power was still on, the receiver type and
servo response return to their previous mode. When the receiver type and servo
response were changed, use the model reset function after turning the power off
and on.
2
(Model reset execution)
Move the cursor to EXEC:+/- by (UP) or (DN) button and
press the (+) and (-) buttons simultaneously for approximate-
ly 1 second. A beeping sound is generated and the model
data is reset.
-Resetting is complete when "OK!" is displayed on the screen.
3
When ending, return to the menu screen by pressing the (CT)
button.