Futaba 18MZ 2.4GHz - Manual (Page 159)

159 <Data>
Switch selection method
The various functions used in the T18MZ can be selected by switch. The switch (including when stick,
trim lever, or VR are used as a switch) setting method is common to all functions.
Switch mode selection (Single switch/Logic switch)
When the switch select button in a mixing function screen or other screen is touched, the switch mode
selection screen shown below is called. Single mode or logic mode can be selected.
(Switch mode selection screen example)
Logic switch
The Logic switch can activate functions by the use of other switch
combinations. Up to 4 switch combinations can be set. The Logic switch can
be assigned to the mixing function as well as the flight condition select (except
for Snap roll function on airplane mode).
●Mode selection button
●Switch selection button
*In case of the flight condition select, the top of
the switch on/off status display is not shown.
If using the single switch:
1. Push the switch selection button.
*The switch selection screen appears.
If using the logic switch:
1.The switch mode display is changed by
pushing the mode selection button. And then
push the [Yes] button.
*The logic mode setting screen appears.
*For a description of the logic mode setting method, see the
section "Logic switch" below.