Futaba 18MZ 2.4GHz - Manual (Page 71)

71 <Linkage Menu>
●Return to Linkage Menu
●Check mark
● Touch the [Model Select] button in the Linkage Menu to call the setup screen shown below.
Model Select The Model Selection function performs model addition, selection, deletion,
copy, and model name setting.
This function is used to load the settings of the
desired model into the T18MZ’s memory.
The settings may be selected from either the
transmitter’s built-in memory or a SD card/USB
memory.
The name of the model stored in the transmitter and
the SD card/USB memory may be changed. This can
be very useful to tell different models settings apart.
Each model name can be as long as 32 characters, and
the model name always appears in the display screen.
The Copy function is used to copy one set of model
data into a second memory within the transmitter and
the SD card/USB memory. It may be used for getting
a head-start on setting up models with almost the same
settings (only differences need to be modified, instead
of entering the complete model from scratch). Also,
this function may be used to make a backup copy of a
model setup before any changes are made.
(The display screen is an example. The screen depends on the model type.) (Model list)
Model call
1. Touch the "Location" icon, and select the
location to which the desired model is to be
saved.
Transmitter icon: Transmitter memory
SD card icon: SD card
USB memory icon: USB memory
2. Touch the desired model in the model list.
3. Touch the [Select] button.
4. Touch [Yes] to call the model. (When you
want to cancel model call, press [No].)
Model addition
1. Touch the [New] button.
2. Touch [Yes] to add the model. (When you
want to cancel model addition, touch [No].)
*When a new model is added, the Model Type screen is
automatically displayed. Check or change the model. If
there are no changes, touch the Model Type icons.
*The added model is displayed in the model list.
Model deletion
1. Touch the "Location" icon or the model you
want to delete in the model list. (The model
currently selected cannot be deleted.)
2. Touch the [Delete] button.
3. Touch [Yes]. (When you want to stop model
deletion, touch [No].)
Model name change
1. Select the model by touching the "Location"
icon or the desired model in the model list.
2. When [Rename] is touched, a keyboard
appears on the screen.
3. Enter the model name from this keyboard.
*Up to 32 characters can be input at the model name.
Model copy
1. Select a model to copy from the list.
2. Check mark is attached to the model and a
"Copy" button is displayed on the right.
3. Touch the "Copy" button and Touch the
"Destination" button and select the copy
storage destination. (Transmitter or SD card/
USB memory)
4. Touch the center [Copy] button.
5. When [Yes] is touched, copying is executed.
(When you want to cancel copying, touch
[No].)
* If there is no model with the same name in the copy
destination, the name of the copied model is saved. If there
is a model of the same name, a number is added at the end
of the model name and the model is copied. You can change
the name later.
*When the model data is copied, the model dateis reset to the
date that the copy was done.
●"Location"
●It can sort in order
of the date or a
name.