Futaba 18MZ 2.4GHz - Manual (Page 47)

47 <System Menu>
Operation direction reversal method
1. Touch the setting button corresponding to
the H/W (Hardware) you want to reverse.
2. Reverse the H/W by touching [Yes]. (When
you want to stop operation, touch [No].)
[Normal]: Normal operation direction
[Reverse]: Reverses the operation direction.
H/W Setting Stick, switch, trim lever, and knob operation direction reversal (Hardware
reverse)/Stick response and hysterisis adjustment (Stick Setting)/Calibration
This function is for adjusting the sticks, switches,
and trim characteristics. It is not unless necessary.
H/W Reverse
This function reverses the operation signal of the
sticks, switches, trimmer levers, and knobs.
Note: This setting reverses the actual operation
signal, but does not change the display of
the indicators on the display. Use the Normal
mode as long as there is no special reason to
use the Reverse mode.
● Touch the [H/W Setting] button at the System
Menu to call the setup screen shown below.
●Return to System Menu
Stick Setting
This function sets the servo response and
hysteresis for stick operation for each condition.
The control feeling of the stick can be adjusted to
match the aerobatics.
Calibration
Usually, this calibration is unnecessary.
Please perform this calibration, only if a change
at the center of a stick should arise after prolonged
use.
● Touch the [H/W Reverse] button at the H/W
Setting Menu to call the setup screen shown
below.
●Return to H/W Setting Menu