Futaba 18MZ 2.4GHz - Manual (Page 36)

36 <Basic Operation>
Registration of the user's name
T18MZ transmitter can register user's name.
How to register user's name
1. Turn on the power of the transmitter.
2. Push the area of the user's name shown on
the home screen or the "user's name" in the
linkage menu. Then the User's Name Set
screen will pop up.
85%
User Name Model1
User Name
User ID
Secure Mode
Futaba Corporation
0000
System
3. Push the user's name. Then the keyboard will
pop up. You can use up to 32 characters
as a user's name. Use the keyboard on the
screen to enter user's name.
space key
Enter and Exit : [Return] Key, Cancel and Exit : [ESC] Key
Piease input user name. (≦ 32 Characters )
Futaba Corporation
4. Push "Return" key to return to the previous
screen after entering the user's name.
(If you want to protect the user's name)
If you don't want anybody else to change your
user's name, set your ID in the following way.
*Please be aware that you will not able to change user's name
if you forget your password.
1. Make sure that the security mode is "User's
name", and then push the User ID button.
2. Enter your password, using keyboard on the
screen. You will need to enter your password
for changing the user's name, the next time
you turn on the power.
*Even if you enter the same character, your password will be
identified differently depending on whether you are using
"Transform" mode or "Direct" mode for inputting.
off the power, some part of the circuit is consuming
current. When you turn on the power during this
period, the power starts in “Hot mode”. But if more
than four hours pass after shutting down the power,
the power supply will completely shut down the
internal circuit. When you turn on the power after
this point, the power starts in “Cold start mode”.
How to reset software
If the screen freezes for some reason and you
cannot edit, the transmitter power supply is not
fully off even if you turn OFF the power switch.
You will need to remove the battery and reinsert
it again. In this case, the power restarts in “Cold
mode”. Even though the screen freezes, all the
other functions for radio control operation remain
operative.