Futaba 18MZ 2.4GHz - Manual (Page 81)

81 <Linkage Menu>
(The display screen is an example. The screen depends on the model type.)
Trim change
1. Touch the Trim button to call the Trim setup
screen.
2. The following items can be set at the Trim
setup screen.
● Hardware setting (Selection of switch, etc.
which controls trim) (The select screen is
called by touching the [H/W Select] button.)
● Rate setting
● Operation step setting
● Trim mode setting
Normal mode: Normal trim (linear) operation
SWAP
If [SWAP] is pushed, it will call up the following
screen. You can easily change two separate
functions, keeping the data that was set for each
channel.
1. Touch the Trim button two channels to
change is pushed.
2. If [OK] is pushed, two channels will
interchange.
*It can choose only to two.
ATL mode: ATL operation mode. (Works at only one
end of operation) Reverse is also possible.
CTRM mode: Maximum change near center by
center trim operation (Does not change at end of
the stick movement)
● Separate/combination mode: Trim data can
be set to different flight conditions
Separate mode: Trim adjustment for each separate
flight condition.