Futaba 18MZ 2.4GHz - Manual (Page 161)

161 <Data>
Switch selection
When the switch selection button in switch mode selection screen or the logic switch setting screen is
touched, the screen below is shown.
(Switch selection screen example)
When switch is selected
Switch ON/OFF setting is possible at each
position.
●Alternate: Alternate switching mode is
available depending on mixing function.
1. When the ON position switch is touched after
the switch was selected, the screen shown
below appears.
*When the button of each position is touched,
it toggles between ON and OFF.
2. Touch the button and set to the ON position.
3. Close the screen by touching [Close].
When stick, trim lever, or VR is selected.
When a stick, trim lever, or VR is used as a
switch, the following 4 modes can be selected.
●Mode: Lin/Sym
●Type: Hysteresis (Hys.)/box (Box)
1. When the ON position button is touched after
stick, etc. was selected, the screen shown
below appears.
2. Select the mode you want to use, and set it
as described below.
3. Close the screen by touching [Close].