Futaba 18MZ 2.4GHz - Manual (Page 78)

78 <Linkage Menu>
WARNING
Do not perform the linking operation when the
drive motor is connected and the engine was
started.
■ Inadvertent rotation of the motor or acceleration of the engine
is extremely dangerous.
Once the link operation is complete, please check
that your receiver can be operated with the linked
transmitter.
Check operation sufficiently before flying after
linking.
■ If the same receiver is sending in the vicinity, there is the danger
that the transmitter may be linked with that receiver.
CAUTIONS
Always turn on the transmitter power after linking
is complete.
When pairing with the transmitter, be sure that a
previously linked transmitter is not transmitting
Linking method (T18MZ ↔ R7008SB)
1. Bring the receiver to be linked to within 50cm
of the transmitter.
2. Press the [Link] button in the [Link] box of
[System Type].
3. The transmitter emits a chime sound and enters
the link mode.
4. The receiver power is immediately turned
on.About 2 seconds after the power is turned
on the receiver enters the linking state.
(Receiver linking time is about 1 second)
5. If linking is successful, the receiver LED changes
from red to green, the link mode ends, and the
receiver ID code is displayed.
6. If linking fails, an error message is displayed.
Bring the transmitter closer to the receiver and
repeat the procedure above from Step 2.
*Do not perform the linking operation when the drive motor is
connected or the engine is running.
* When you use two receivers, please be sure to setup a
"primary" and "secondary" in the "dual" mode.
*Since two sets of receivers cannot be individually recognized
without using a "primary" and "secondary" setup, it is
impossible to receive telemetry data correctly.
* You must link one receiver at a time. If both power supplies
to the receivers are switched on simultaneously, data is
received incorrectly by the transmitter.
* If a dual receiver function is used, in order to receive sensor
information correctly by both sets, telemetry data will be
slower compared to a single receiver setup.
* You cannot link three sets of receivers.
● Touch the [Link] button in the System Type
Menu to call the setup screen shown below.
● Battery fail-safe voltage setup (only
FASSTest mode)
●Return to System Type
Menu