Futaba 18MZ 2.4GHz - Manual (Page 97)

97 <Linkage Menu>
●Return to Linkage Menu
● Touch the [Sensor] button in the Linkage Menu to
call the setup screen shown below.
Sensor Various telemetry sensors setting.
Procedure for changing the sensor of each slot No.
1. Select [Sensor] from the Linkage Menu.
2. Select the sensor of the slot No. to be changed.
3. Select the type of displayed sensor.
4. When the [Yes] key is pressed, the type of sensor is
changed.
*In the case of a sensor which uses more than one slot, you may
be unable to reassign.
The telemetry sensor slot No. and which sensor
is used in each slot can be changed in this screen.
Since the sensor in each slot is determined at
initialization and the same slot No. is memorized
even for sensors sold separately, sensors can be
used by simply connecting them to S.BUS2. When
customizing the sensors yourself, perform the
settings in this screen.
[What is a slot?]
Servos are classified by CH, but sensors are
classified in units called “slot”. There are slots
from No. 1 to No. 31.
Altitude sensors and other data sensor units
may use multiple slots.
By the sensor which uses two or more slots,
the required number of slots is automatically
assigned by setting up a start slot.
When 2 or more of the same kind of sensor
are used, the sensors themselves must allocate
unused slots and memorize that slot.
*Three slots of altitude sensor are used.