Conair WSB User Manual
Page 11
PRESS "REG" KEY Regrind air solenoid will operate.
LED # 1 will light.
The Regrind dump valve will open.
Press "REG" repeatedly to observe operation.
PRESS "NAT" KEY Natural air solenoid will operate.
LED # 2 will light.
The Natural dump valve will open.
Press "NAT" repeatedly to observe operation.
PRESS "COL" KEY Internal relay will close powering Color outlet.
Color feeder will run.
LED # 3 will light.
Press "COL" repeatedly to observe operation.
PRESS "ADD" KEY Relay will close powering Additive outlet.
Additive feeder will run.
LED # 4 will light.
Press "ADD" repeatedly to observe operation.
PRESS "DUMP" KEY The dump air solenoid will operate.
LED # 5 will light.
The weigh bin dump valve will open.
Press "DUMP" repeatedly to observe operation.
PRESS "ALARM" KEY The Strobe Light and Beeper will operate.
LED # 6 will light.
PRESS "MIX" KEY The Mixer Motor will run.
LED # 7 will light.
(Mix blade turns counter clockwise when observed
through window.)
(Mixer switch must be down; timed position.)
PRESS "HOLD" KEY The Flow Control Valve will operate.
(This is an optional device).
LED # 8 will light.
PRESS "EXIT" KEY Press two times to return to normal mode.
Verify normal mode by observing that there is NO
letter P in the display ( x.x).
+-----------------------------------------------------------+
¦ If you have made it this far, congratulations. ¦
¦ You have done well. ¦
¦ The load cells and controller are functioning properly. ¦
+-----------------------------------------------------------+
+--------------------------------------------------------+
¦ ¦
¦ PROCEED TO: LOAD CELL CALIBRATION Skip 2 Pages ¦
¦ ¦
+--------------------------------------------------------+
Page 12