Conair WSB - Manual (Page 34)

A new setting may be entered at this time by keypad if so
desired. (CE will cancel entry before last digit is
entered.) Settings entered by keypad CAN NOT BE ALTERED by
the thumbwheel switches. After entering a setting by
keypad, verify this by rotating the appropriate thumbwheel
switches. An LED will light indicating that the internal
setting being used by the computer does not match the
thumbwheel switches.
The display of a setting followed by pressing the "CE" key,
will revert that setting back to thumbwheel control and will
also exit the sequence. EXIT will exit the sequence.
This function will positively fix the settings so that
thumbwheel switches have no control and no one can change
them without authorization. An LED will light indicating
this override condition. The LED will be lit ONLY when the
thumbwheel setting does not match the internal setting.
To allow the operator the ability to stop running this
component, a setting of all ZEROS (00.0) is still accepted
as valid and will override any setting that has been entered
by keypad. If you do not want this override option, enter a
1 as the first digit in the SE parameter. See PARAMETERS,
_SE.
To later return to thumbwheel control, use the same
procedure as above except instead of entering a setting,
press the "CE" key when you see the setting displayed.
PARAMETERS: Press the PARA key to display the table of operating
(PARA) parameters that reside in memory. There are more then 60
parameters, and each successive press of the key displays
the next parameter in the table. Pressing the "*" key
allows you to back-up in the table. You may change a
parameter by entering a new number over the old one. CE
will cancel a number entry before the last digit is entered.
All parameters are fully explained several pages forward in
this manual. EXIT will exit the sequence.
STAR FUNCTIONS.
*02 This flag for EXTRUSION and YIELD control.
Press (*,0,2) to turn on Extrusion or Yield control.
The default display is ( OFF).
Press * to toggle this flag to ( RATE ), (EXT CTRL), or
(YLD CTRL).
If you are using our EXTRUSION or YIELD control software to
control your extruder, refer to our EXTRUSION CONTROL
instruction booklet for complete information.
If you simply want to view throughput continuously on the
blender display, set this option to ( RATE ). This will
Page 35