Conair WSB - Manual (Page 96)

COMPUTER OUTPUTS - WIRING SUPPLEMENT
17 pin connector
This computer output;
| drives this device on the board;
| that goes to the outside world through this connector;
| to drive this external device.
| wire color
|
formerly optical coupler outputs
| 17 pin Amphonal connector
|
1 1 pin A weigh bin dump air solenoid brown
2 2 pin B component 1 air solenoid orange
3 3 pin C component 2 air solenoid blue
4 4 pin D component 3 air solenoid (add) gray
5 5 pin E component 4 air solenoid (col) purple
6 6 pin M flow control air solenoid yellow
7 7 pin F component 7 air solenoid red
solid state plug-in relays (4) on separate board
|
8 1 comp. 5 - additive auger motor outlet, panel front
9 2 comp. 6 - color auger motor outlet, panel front
10 3 strobe and beeper + opt. alarm relay output
11 4 mix motor outlet, panel side
12 5 pin G comp. 8 - external SS relay wt./red
13 6 pin H comp. 9 - external SS relay wt./yellow
14 7 pin J comp. 10 - external SS relay wt./green
15 8 pin K comp. 11 - external SS relay wt./blue
pin L alarm
pin N common line, all outputs. +24v white
pin P comp. 12 (also air drive mixer)
pin R neutral to 10 volt signals (S,T)
pin S 0-10 volt extruder control signal
pin T 0-10 volt line speed control signal
External SS relays are optional.
External SS relays and air solenoids may be exchanged.
Page 97