Conair WSB User Manual
Page 4
Page 2
GETTING STARTED, READ THIS PAGE.
THE NEXT 9 PAGES OF THIS MANUAL WILL GUIDE YOU, STEP BY STEP, TO A
SUCCESSFUL STARTUP.
IT WON'T TAKE LONG; SO.... PLEASE, DON'T SKIP AHEAD.
HERE ARE THE STEPS YOU WILL FOLLOW.
SAFETY HAZARDS: Two hazards exist on this unit: mix blades and
Page 4 slide valves. Read this short sensible page
so no one gets hurt.
ASSEMBLY INSTRUCTIONS: Very little assembly is required. But you
Page 6 might as well get it right the first time.
ALSO: pay attention to the section on wiring.
CHECK OUT PROCEDURE: This is to see if you did it right. It also
Page 11 will tell if anything was damaged in shipping.
LOAD CELL CALIBRATION: We already did this. But shipping or rough
Page 15 handling during assembly sometimes creates load
cell problems. If weight readings are not
correct, you MUST recalibrate the load cells.
RATE CALIBRATION: This is NOT really necessary. But if your
Page 16 system uses non-standard equipment then you
MAY want to do this.
SPECIAL INSTRUCTIONS: A few selected models require special
Page 17 instruction. If your model is listed on this
page, read these instructions.
NORMAL OPERATION: From this point forward, operating your system
Page 18 is a snap. This section tells you just how
simple it is and exactly what to expect under
normal operating conditions.
SPECIAL FEATURES: Your system can do much more then you may
page 19 know. This page reviews briefly some of the
added features that are available to you and
where in this manual you can find them.
+---------------------------------------------------+
¦ ¦
¦ PROCEED TO: SAFETY HAZARDS NEXT PAGE ¦
¦ ¦
+---------------------------------------------------+