Conair WSB - Manual (Page 83)

NATURAL second:
The NATURAL dispense occurs next in the sequence. The letter
"N" will appear in the display. The exact weight of the
NATURAL dispensed is now determined for calculating the COLOR
and ADDITIVE dispenses. The TOTAL weight of NATURAL and
REGRIND combined will appear in the display 3 seconds AFTER
the Natural dispense has ended.
COLOR third and ADDITIVE fourth:
COLOR is dispensed followed by ADDITIVE as requested by the
thumbwheel switch settings. Each dispense must meet
requirements set by internal parameters or RETRIES will occur
and the sequence will not continue.
MATERIAL RUNS OUT:
If any material runs out or is not enough to meet criteria
set by the internal parameters then the process will NOT
CONTINUE past this component. RETRIES of this dispense will
occur indefinitely until the full dispense occurs or power is
turned off. The display will FLASH. The ALARM will sound
after 4 retries. This number of retries before alarm is
based on the ALARM (_AL) parameters. REGRIND may, or may
not, be set to ALARM when it runs out. See PARAMETERS, (RAL
00000), to change this.
If ALARM flashes:
More than four retries of any single component will cause the
strobe light ALARM to begin flashing. The component that is
causing the alarm will continue to retry the dispense. The
display will blink and the LETTER in the display will signify
which component is causing the problem. To continue with the
dispense sequence, you must satisfy the requirements of the
dispense or turn power off.
WEIGH BIN dump:
After all dispenses the weigh bin is emptied by the final
dump of the weigh bin into the mixing chamber. The dump valve
remains open for six seconds.
SENSOR covered:
While the sensor is covered, the dump valve remains open to
ensure the weigh bin empties completely. Dispensing stops.
The dump valve will remain open for as long as the sensor is
covered. Uncovering the sensor will begin the next cycle.
FLOW CONTROL Valve: (optional)
If your unit has a Flow Control Valve under the mix chamber,
this valve will stay closed for the 6 seconds immediately
following a dispense into the mix chamber. (time is based on
the FCV parameter). At all other times it opens when the
sensor is covered, and closes when the sensor has been
uncovered for 2 full seconds.
Page 84