Conair WSB - Manual (Page 19)

To run a LOWER PERCENTAGE then 00.1 percent, read:
PARAMETERS, _XT parameter.
To place UPPER LIMITS on the thumbwheel settings, read:
PARAMETERS, _SE Parameter.
To LOCK OUT others from changing settings, read:
KEYPAD, STAR FUNCTIONS, (*78) - Changing the Password.
To blend TWO NATURAL materials instead of Natural and Regrind, read:
KEYPAD, STAR FUNCTIONS, (*69) - the TWO NATURALS flag.
To TRACK MATERIAL usage, read:
KEYPAD, VIEW DATA, and PARAMETERS, PRT Parameter.
To VERIFY ACCURACY of the entire system, read:
PRINTER OUTPUT and TROUBLESHOOTING sections.
READ the rest of the manual at your leisure to learn more about how
your WEIGH SCALE BLENDER works and what else it can do.
KEYSTROKE SEQUENCE for these or other SPECIAL FEATURES
With STOP END OF CYCLE switch DOWN,
Turn POWER ON. Wait 5 seconds, until display says ( x.x)
Press: * Display will say (PASSWORD)
Press: 22222 Display will say (P x.x)
This is the PROGRAM MODE
To alter a PARAMETER; press: PARA key
Press repeatedly until the parameter you want is displayed.
If you pass it, use the * key to back up.
With the proper one displayed, enter the NEW parameter number.
Enter 5 digits; use leading zeros if necessary.
For correct entries, follow specific directions given in the
PARAMETER section.
Press: EXIT when correct parameter has been entered.
To make a (*XX) entry:
Be in the PROGRAM mode, same as above.
Display will say (P x.x)
Press: * Display will say (INSTR --)
Enter the 2 digit code.
For correct entries, follow specific directions given in the
KEYPAD section, STAR FUNCTIONS.
Press: EXIT when correct information has been entered.
When finished, press EXIT again to exit the PROGRAM MODE.
Page 20