Keri Systems TAP100 - Manual (Page 16)

TAP 100 Application Software Manual
Page 16 Revision 3.3
Use your pointing device and select Utilities, and then select Change System PIN. The following
prompt box will appear, asking for the new 4 digit PIN.
The status message line will display:
Enter your new four digit PIN by typing the desired digits.
For example: To enter a new PIN of 1 2 3 4 type:
1 2 3 4 <ENTER>
The following prompt box will appear.
Use your pointing device and select YES/OK if you have entered the desired PIN. The TAP100
software will initiate communication with the control unit/readers on the network to inform them of
the new PIN. Once communication is complete, the system will confirm the new PIN with the
following prompt box.
NOTE: If you have changed your PIN, you must re-enter your PIN as described in the
Entering Your PIN section on page 14, before the TAP100 software will allow any system
configuration changes.
If you have selected NO/CANCEL to exit the selection and cancel the new PIN, the system will
confirm the cancellation with the following prompt box.
You are about to change the system PIN.
DO YOU REALLY
WANT TO DO THIS?
YES/OK
Set System PIN
Enter new PIN: + + + +
NO/CANCEL
Change the system PIN to a new value.
Successfully changed system PIN.
You must now enter your PIN in the
SETUP menu to communicate with the
ProxLock master.
OK
System PIN not changed.
OK