Keri Systems TAP100 - Manual (Page 42)

TAP 100 Application Software Manual
Page 42 Revision 3.3
If all of the assignment information is correct, use your pointing device and select OK. The
TAP100 software will return to the I/O Assignments prompt box and display the following
information.
Once the I/O assignments have been made, you can PRINT a hard copy of the information just
entered. This will allow you to review the I/O assignment information one last time before sending
this information to the control units. To print a hard copy of the I/O assignments, use your pointing
device and select PRINT. The following prompt box will appear.
As the I/O assignment information is being printed, the status bar in this prompt box will monitor
how far along the print process is. When the print job has finished, you can review the I/O
assignment information and verify it is correct. The printout will appear something like this.
I/O ASSIGNMENTS
INPUT INPUTS OUTPUT OUTPUTS
LINK READER 1 2 3 4 PC READER 1 2
1 Reader 2 (01) N PC Reader 2 (02) M
2 -----Available -----
3 -----Available -----
• • •
0 Reader 1 (01) N PC Reader 2 (02) M
MODIFY PRINT SEND CLEAR QUIT
I/O ASSIGNMENTS FOR LINK 1
Input Reader: Sup I/O: No Polarity: Norm. Closed
Input Lines:
1
2
3
4
Output Reader:
Output Lines:
1
2
2 Reader 2
( ) Active ( • ) Normal ( ) Tamper ( ) None
( ) Active ( ) Normal ( ) Tamper ( ) None
( ) Active ( ) Normal ( ) Tamper ( ) None
( ) Active ( ) Normal ( ) Tamper ( ) None
[ X ] Send to PC 2 Reader 2
( ) Not Used ( ) Deactivate ( ) Activate ( ) Momentary
( ) Not Used ( ) Deactivate ( ) Activate ( ) Momentary
OK QUIT
Print Job Progress
0% 100%
Press ESC to abort the print job.
DISABLE