Keri Systems TAP100 - Manual (Page 36)

TAP 100 Application Software Manual
Page 36 Revision 3.3
Once all reader database entries have been made, you can PRINT a hard copy of the readers
database. This will allow you to review the entire reader database one last time before sending
this information to the control units.
To print a hard copy of the reader database, use your pointing device and select PRINT. The
following prompt box will appear.
As the reader database is being printed, the status bar in this prompt box will monitor how far
along the print process is. When the print job has finished, you can review all reader database
entries and verify they are correct. The printout will appear like this.
TAP-100 VERSION X.XX Door/Reader Information
DATE TIME page #
==========================================================
RDR NAME (Ant A) TIME TIME ZONES APB I/O CTRL POL
1 no name 1-A 20s 5s 7 7 N N Y N/C
2 no name 1-A 20s 5s 7 7 N N Y N/C
3 no name 1-A 20s 5s 7 7 N N Y N/C
4 EMP ENTRA 40s 20s 7 7 Y Y Y N/C
5 no name 1-A 20s 5s 7 7 N N Y N/C
• • •
Once you have reviewed the reader database and are satisfied with all its entries, you must send
this information to all control units on the network. Use your pointing device and select SEND.
The status message line will display:
Modifying Reader 4
Reader Name A EMP ENTRANCE
Reader Name B EMP EXIT
Open time (seconds) 40
Unlock time (seconds) 20
Local APB enabled (Y/N) Y
Auto-Unlock time zone 1 07
Auto-Unlock time zone 2 07
Supervised I/O (Y/N) Y
Alarm Control (Y/N) Y
Input Normal Polarity (O/C) C
Press ENTER to accept, ESC to abort
Initiating communication with local network on COM1 . . . please wait.
Print Job Progress
0% 100%
Press ESC to abort the print job.