Keri Systems TAP100 - Manual (Page 46)

TAP 100 Application Software Manual
Page 46 Revision 3.3
If all of the assignment information is correct, use your pointing device and select OK. The
TAP100 software will return to the I/O Assignments prompt box and display the following
information.
Once these I/O assignments have been made, you can PRINT them to review the entered
information. Follow the instructions provided on page 39 for the ‘OR’ I/O assignment section.
Once you have approved this information, you must SEND it to all control units on the network for
them to take affect. Follow the instructions provided on page 39 for the ‘OR’ I/O assignment
section.
Clearing All I/O Assignments
If a major change needs to be made to the I/O assignment for the network, it may be easier to
clear the entire I/O assignment table and create a new one instead of editing the existing table.
To clear the entire I/O assignment table, use your pointing device and select Utilities and then I/O
Assignments. The following prompt box will appear.
I/O ASSIGNMENTS
INPUT INPUTS OUTPUT OUTPUTS
LINK READER 1 2 3 4 PC READER 1 2
1 Reader 2 (02) N PC Reader 2 (02) M
2 -----Available -----
3 Reader 3 (03) N PC Reader 2 (03) M
• • •
This will clear all links in the I/O assignment list.
DO YOU REALLY
WANT TO DO THIS?
0 Reader 1 (01) N PC Reader 2 (02) M
YES/OK
MODIFY
NO/CANCEL
PRINT SEND CLEAR QUIT
I/O ASSIGNMENTS FOR LINK 3
Input Reader: Sup I/O: No Polarity: Norm. Closed
Input Lines:
1
2
3
4
Output Reader:
Output Lines:
1
2
3 Reader 3
( ) Active ( ) Normal ( ) Tamper ( ) None
( ) Active ( ) Normal ( ) Tamper ( ) None
( ) Active ( ) Normal ( ) Tamper ( ) None
( ) Active ( ) Normal ( ) Tamper ( ) None
[ X ] Send to PC 3 Reader 3
( ) Not Used ( ) Deactivate ( ) Activate ( ) Momentary
( ) Not Used ( ) Deactivate ( ) Activate ( ) Momentary
OK QUIT DISABLE