Keri Systems TAP100 - Manual (Page 31)

TAP100 Application Software Manual
Revision 3.3 Page 31
system. To set holidays, use your pointing device and select Utility and then Holiday. The
following prompt box will appear.
All holiday dates must be entered in a month/day format with two characters for the month and
two characters for the day (i.e. January 1 is entered as 01/01). All unassigned holiday dates will
be listed with a date of 00/00. Use your pointing device, select the first holiday entry date, and
then select Modify. The following prompt box will appear.
Enter two characters for the month, followed by two characters for the day. If you need to correct
an entry, use the arrow keys to select the character and type over it with the correct character. If
you wish to exit without entering this holiday, use your pointing device and select QUIT. If you are
satisfied with your entry, use your pointing device and select OK. This will return you to the
original holiday table where your change should now appear.
Repeat this process for each holiday required to meet your application’s needs.
Once all holiday entries have been set, you can PRINT a hard copy of the holiday table. This will
allow you to review the entire holiday entry table one last time before sending this information to
the control units. To print a hard copy of the holiday schedule table, use your pointing device and
select PRINT. The following prompt box will appear.
As the holiday schedule table is being printed, the status bar in this prompt box will monitor how
far along the print process is. When the print job has finished, you can review all holiday schedule
entries and verify they are correct. The printout will appear like this (a possible holiday schedule
for 1995).
HOLIDAY SCHEDULE
NUM DATE
1
2
3
4
5
6
7
8
MODIFY
PRINT
SEND
QUIT
Month: 00
Date: 00
OK QUIT
Print Job Progress
0% 100%
Press ESC to abort the print job.