Keri Systems TAP100 - Manual (Page 37)

TAP100 Application Software Manual
Revision 3.3 Page 37
When this process is complete, the status message line will display:
Query Status of a Reader
The query status of a reader command gives a table of all current operating parameters defined
for that reader. To query the status of a reader, you must know the address of the reader to
query. Use your pointing device and select Readers and then Query status of a reader. The
following prompt box will appear.
For example: To query the status of reader 4 as entered in the reader database above, type:
4 <ENTER>
Communication will begin with the selected reader and the Status Message Line will display:
Once communication is complete, the following prompt box will appear.
Review this table for the status information of the requested reader.
Global Secure
The global secure command locks all doors on the network at a specified time of day, except for
those doors that are programmed to be unlocked per the auto-unlock function of the reader
database. This ensures that any door not specifically programmed to be open is automatically re-
locked once a day. The factory default value for global secure is 20:00 hours (8 P.M.).
Initiating communication with local network on COM1 . . . please wait.
Reader number to query: (1-32) ___
Done.
Information on Reader 4
Firmware Version: 2.23
System ID: 0
Power On Count: 0
Watchdog Count: 0
POST Fail Count: 0
Dual Door: Y
Local Anti-Passback: Y
Open Time: 40seconds
Unlock Time: 20seconds
Door Status: Secured
Card Holders: 3
Events in Log: 17
Temporaries: 0
Reader’s Date: Tue 07/04/95
Reader’s Clock: 13:30:54
Press any key when finished.