Keri Systems TAP100 - Manual (Page 49)

TAP100 Application Software Manual
Revision 3.3 Page 49
Use your pointing device and enter the starting slot and the ending slot. If you are not satisfied
with your entry, select QUIT to exit the selection without making a change. If your entry is correct,
use your pointing device and select OK.
For example: If you are entering one card into slot 5, the following prompt box will appear asking
you to confirm this entry.
Or, if you are entering 6 cards into slots 5 through 10 the following prompt box will appear.
If you are not ready to enter cards, use your pointing device and select NO/CANCEL. If you are
ready, select YES/OK. The following prompt box will appear.
The status message line will display:
Once communication is established, the following prompt box will appear.
One at a time, as prompted by the system, present the cards to be enrolled to the reader. As
each card is read and recognized by the reader, the reader will beep twice and briefly display the
following prompt box to indicate acceptance.
Initiating communication with local network on COM1 . . . please wait.
You are about to enroll 1 cards at slots 5 to 5.
DO YOU REALLY
WANT TO DO THIS?
You are about to enroll 6 cards at slots 5 to 10.
DO YOU REALLY
WANT TO DO THIS?
YES/OK
YES/OK
NO/CANCEL
NO/CANCEL
BATCH ENROLL MODE
Opening channel to PROX.
BATCH ENROLL MODE
Now enrolling card at slot 5.
Present card to reader. . .
QUIT