Keri Systems TAP100 - Manual (Page 27)

TAP100 Application Software Manual
Revision 3.3 Page 27
Set Daylight Savings Time
To enable or disable the one-hour daylight savings time change, use your pointing device and
select Utility and then Daylight Savings. The following prompt box will appear.
The status message line will display:
Use your pointing device and select Enabled or Disabled to match the current daylight savings
mode and select OK. Or, select QUIT to exit the selection without making a change.
NOTE: Daylight Saving Time for all U.S states, the District of Columbia, and U.S.
possessions begins at 2 A.M. on the first Sunday in April and ends at 2 A.M. on the last
Sunday in October.
Set Time Zones
A time zone is a defined block of time that is assigned to a card to allow access. A time zone
consists of either an all encompassing categorization of Never or Always, or it consists of a
definition of the hours and days of the week that access is allowed. Careful setting of the time
zones is critical to the proper operation of your access control system. It is through the use of
time zones that automatic entry and automatic securing of your controlled areas are set.
To begin the set time zone process, use your pointing device and select Utility and then Time
Zones. The following prompt box will appear with the factory default time zone values.
In the above prompt box, TZNUM refers to the identification number for a time zone, ACCESS
PERIOD refers to the period of time that time zone will allow access to the controlled area, and
DAYS OF THE WEEK refers to the days of the week to which the access period is applied.
Daylight Savings Mode
( ) Enabled
( • ) Disabled
OK QUIT
Choose daylight savings time state.
TIME ZONES
TZNUM ACCESS PERIOD DAYS OF THE WEEK
1 07:00 – 18:00 So Mo Tu We Th Fr Sa
2 15:00 – 00:30 So Mo Tu We Th Fr Sa
3 23:30 – 07:30 So Mo Tu We Th Fr Sa
4 07:00 – 16:00 So Mo Tu We Th Fr Sa
5 23:00 – 03:00 So Mo Tu We Th Fr Sa
6 External
7 Never (fixed time zone)
8 Never
MODIFY PRINT SEND QUIT
0 Always