LAARS NeoTherm NTV (Sizes 399-850 MBTU/h) - Service Manual - Manual (Page 88)

78 Service Manual - NeoTherm 500
Using the Current User Interface
This interface is used on all NeoTherm models produced since 2012.
The table below lists the functions of the various parts of the user inter-
face. In a moment, we will explain how to use the buttons to reach the
different sections of the control system.
Display area
Up/Down
Arrow
buttons
Left/Right
Arrow
buttons
Back button
Info/Install
button
Home button
Round OK button
Fig. D5-1 - Control buttons on current user interface
Display area This area displays several different kinds of information, including current op-
erating information, setup parameters, and messages from the SOLA control-
ler.
Up/ Down Arrow buttons Use these to go to the choice you want to select in the display area, then
press the round OK button.
Left/ Right Arrow buttons Use these to go to the choice you want to select in the display area, then
press the round OK button.
Back button Use this to go back to the previous display.
Info/ Install button Press this button at any time to go to the sub-menus that allow you to set up
and monitor the controller.
Home button Press this button at any time to go back to the Home display. (See the section
on “Home Display.”)
Round OK button Use the round OK button to confirm a value or action.
Note – Sometimes the system will present the Keyboard display screen, which
also includes a separate “OK” area. This is not the same as the round OK but-
ton – the two have different functions.)
Table D5-1 - Button Functions on Current User Interface
D5