Toa FS-7000 SERIES Installation - Manual (Page 29)

29
* Fuses of ratings over 4 A can be used only when the
FS-7012PA is connected.
6. CONNECTIONS
6.1. Basic System Configuration
The basic system consists of the FS-7000CP, FS-7000JP, FS-7000PS, and FS-7006PA or FS-7012PA. This
basic configuration allows 1-channel/10-zone general-purpose broadcasts to be made. To configure
scheduled (timer-controlled) broadcasts, telephone paging, or BGM broadcasts other than announcements
using the CP microphone, refer to the specific connection instructions for the relevant pieces of equipment.
Connection examples in this chapter show the FS-7012PA being used as the power amplifier, but the same
wiring instructions also apply to the FS-7006PA.
[System Operation]
• Ten different broadcast zones can be selected individually or simultaneously.
• Broadcasts can be either announcements (made using the CP microphone installed on the FS-7000CP
Control Panel) or background music (BGM).
• The broadcast zones to be used are selected at the FS-7000CP.
• Announcements made using the CP microphone to zones where BGM broadcasts are in progress will be
audible over the BGM in those zones.
[Notes]
• Only 1 FS-7006PA or FS-7012PA unit can be connected to the FS-7000JP's Priority Input. Never connect 2
or more units to this terminal, as the excessive load could cause the amplifier to fail.
• The FS-7000JP's maximum output per speaker line varies depending on the connected power amplifiers.
Maximum power output is 500 W when the FS-7012PA is connected, and 280 W when the FS-7006PA is
connected. If the load capacity exceeds the maximum power output, divide speaker lines into 2 or more
lines.
• A 0.5A fuse is preinstalled by the factory for speaker line protection.
Depending on the total wattage of all the connected speakers on a line, replace the fuse with one having the
correct rating, referring to the following table:
WARNING
The TERMINALS marked with the symbol are HAZARDOUS LIVE.
The external wiring to these terminals requires installation by an INSTRUCTED PERSON.
[Settings]
Set the FS-7000CP's output mode selector switch to "1-CH."
Total Wattage per Speaker Line
Up to 24
25 – 40
41 – 80
81 – 120
121 – 160
161 – 200
201 – 240
241 – 280
281 – 320
321 – 400
401 – 480
481 – 500
Fuse Rating (A)
0.3
0.5
1.0
1.5
2.0
2.5
3.0
3.5
4.0 *
5.0 *
6.0 *
6.3 *
Preinstalled by the factory