Toa FS-7000 SERIES Installation - Manual (Page 34)

34
6.4. Power Amplifier Expansion
Power amplifiers must be expanded when the total of speaker line load capacity exceeds 1,200 W and a
single power amplifier cannot handle this load. However, since only 1 power amplifier can be connected to
each FS-7000JP panel, the number of speaker lines must also be increased by adding the FS-7010CP and
FS-7000JP, even if the number of necessary speaker lines is less than 10.
[Notes]
• Only 1 piece of the FS-7006PA or FS-7012PA can be connected to the FS-7000JP's Priority Input. Never
connect 2 or more units to this terminal, as the amplifier could fail.
• The total of the FS-7000JP's speaker line output must not exceed the power amplifier output.
[Wiring Diagram]
The following figure shows only the wiring related to the power amplifier expansion.
FS-7000CP
FS-7000JP
FS-7012PA
FS-7000JP
FS-7012PA
230 V AC
230 V AC
: Cables prepared separately
See page 66; Table for Cables.
PRIO OUT
PRIORITY IN
PRIORITY IN
INPUT
INPUT
SP OUT
SP OUT