Toa FS-7000 SERIES Installation - Manual (Page 56)

56
6.10. Timer-Operated Equipment
To make timer-operated broadcasts, connect the device equipped with the play make output to the FS-
7000CP's Timer Input as follows. While the Timer Input's (+) and (–) terminals are closed, audio signals
entering the Timer Input are output to all speaker lines.
[Connection Diagram]
6.11. Telephone Paging
To enable telephone paging, connect control and audio signals from the telephone exchange's paging trunk to
the FS-7000CP's Paging Input. While the Paging Input's (+) and (–) terminals are closed, audio signals
entering the Paging Input are output to all speaker lines.
[Connection Diagram]
C
E
H
FS-7000CP
See page 66; Table for Cables. Cable used:
TIMER IN
Audio output
BGM player
Play make output
FS-7000CP
Telephone exchange with
the paging trunk
Audio signal
Control signal
See page 66; Table for Cables. Cable used:
PAGING IN
LEVEL
[Settings]
Set the Paging Input Sensitivity Selector Switch to "–60 dBV" (microphone signal level) or "–20 dBV" (line
signal level) depending on the audio signal level connected to the Paging Input.