Toa FS-7000 SERIES Installation - Manual (Page 73)

73
Step 3. Remove the 5 screws (indicated by the arrow in the figure) that fix the FS-7000GM's case, then
remove the case.
Step 4. Detach the tapes that fix cables from connectors CN4 and CN9.
Cables are affixed to the inside of the unit's bottom surface with tape.
These will be connected in Step 6.
Step 5. Using the supplied screws, mount the soldered circuit board on the mounting sleeves located on the
inside of the unit's bottom surface.
FS-7000GM’s top
Up
FS-7000GM bottom surface
Sleeve
Circuit board
Parts-mounted side
M3 x 4 screw (supplied with the FS-7000GM)
Notes
• Ensure the correct mounting side by confirming the orientation of screw holes when mounting on the circuit
board.
• Take care not to pinch the cables in Step 4 between the circuit board and the sleeves during installation.