Cino PL680BT HC - Manual (Page 11)

W
ir
eless FuzzyScan
R
efer
ence Man
ual
Getting Started
3
Preparation before Using – Gun type Scanners
Install the Battery
Ensure the battery contacts of the battery pack are facing the charging contacts inside
the battery cavity.
Slide the battery pack into the battery cavity until hearing a click sound before locking it
with the end cap. The scanner will give 4 beeps when the battery pack is installed
properly if the battery pack still has power.
Secure the end cap with the screw provided.
Charging the Battery
Choose an appropriate plug and slot it into the power adapter cavity until it is locked.
Then plug the AC power plug into the AC wall socket.
Plug the DC power cord of power supply unit into the DC Jack of the cradle. The smart
cradle emits the power-on beeps and the central indicator gives one blue blink. If you
use the charging cradle, the central power indicator turns steady blue.
Place the scanner on the cradle. The status indicator of scanner turns steady red if the
battery is not fully charged. When the battery is fully charged, the status indicator of
scanner turns steady green.
Please charge the new battery pack for 8 hours before its first use.
Use USB Bus Power
If USB 3.0 is available in your host device, both battery charging and regular operation
can be supported by the USB Bus Power without using external power supply.
If only USB 2.0 is available in your host device, we recommend using external power
supply as power source, because the power supplied from USB2.0 is not enough to
support both battery charging and regular operation simultaneously.
If you want to use this feature, please slide the USB bus power switch to “ON”. Then
connect the cradle to the host device via USB cable.