Cino PL680BT HC - Manual (Page 15)

W
ir
eless FuzzyScan
R
efer
ence Man
ual
Getting Started
7
Use FuzzyScan in PICO Mode
Ensure the battery is fully charged and choose your desired interface cable, then plug it into the host interface port of the
smart cradle and connect it to the host device.
Turn on the power of your host device.
Ensure the side indicators of the smart cradle blink red and green alternatively (in “Uninstall” state). If the smart cradle
is paired with other scanners, please press and hold the paging/reset button for more than 5 seconds to un-pair all
paired scanners. Then the smart cradle will return to uninstall state automatically.
Prepare the scanners you desire to pair with smart cradle. Power or wake up the scanner by pressing the Trigger key if
the scanner is power-off or in sleep state. Ensure the status indicator of each scanner blinks red and green
alternatively (in “Uninstall” state). If the scanner is not in uninstall state, please scan the “Uninstall” command to un-pair
the scanner, then scan the “PICO mode” command, and the status indicator of scanner will light red.
Uninstall PICO Mode
Place the scanner onto the smart cradle, then you will hear one short beep to indicate the pairing process is activated.
The scanner will emit continuous short clicks and the link indicator of scanner will flash blue quickly during the pairing
process. When you hear 4 beeps in ascending tone, the pairing process is completed. You will see that the link indicator
of scanner blinks blue once per 2.5 seconds; the central indicator of the smart cradle lights blue and its side indicators
light green.
If the scanner pairing process failed or it’s not placed on the smart cradle within 20 seconds, you will hear 2 “Di-do Di-do”
beeps to warn the failure of pairing, the scanner will return to uninstall state automatically.
Please scan the corresponding host interface quick set command to complete the installation. Then repeat the same
procedure to pair other scanners with the smart cradle.
For user’s convenience, the smart cradle will automatically assign the ID numbers to each scanner. Please scan the
System Information command to check the assigned ID number of each scanner.
USB PS/2 RS232