Cino PL680BT HC - Manual (Page 95)

W
ir
eless FuzzyScan
R
efer
ence Man
ual
Configure Your FuzzyScan
87
PROGRAM
Condensed DataWizard
♦ Data Formatter Setting ♦
F_DEFAULT
Family Code Selection P.C Parameter Selection Option Code 2nd Option Code
Formatter Control SS
MS
MS
Disable
Select one bar code symbology
Select all bar code symbologies FIN
(2 digits)
00
automatic termination
automatic termination
1st Insertion SS
DS Disable
Enable
2-digits identified position; max. 3 insertion characters FIN
(2 digits)
position
[1-3 characters], [FIN]
2nd Insertion SS
DS Disable
Enable
2-digits identified position; max. 3 insertion characters FIN
(2 digits)
position
[1-3 characters], [FIN]
3rd Insertion SS
DS Disable
Enable
2-digits identified position; max. 3 insertion characters FIN
(2 digits)
position
[1-3 characters], [FIN]
4th Insertion SS
DS Disable
Enable
2-digits identified position; max. 3 insertion characters FIN
(2 digits)
position
[1-3 characters], [FIN]
The Data Formatter is used to edit the scanned raw data prior to transmitting the data to the host computers or terminals. It allows you to select desired bar code
symbologies for formatter control, and provides Multiple Position Insertion and Multiple Character Insertion (max three characters) in the identified position.
While the Data Formatter is enabled, it arranges only scanned data without Preamble, Postamble, STX, ETX, Data Length, Prefix/Suffix Symbolology ID or Record
Suffix. All of the above programmable parameters perform the same function depending on your setting.
Regarding the “Bar Code Selection” and “Position Calculation” of data formatter, please refer to page 60 for details.
Please note that all “Character” input should be referred to the ASCII/HEX Table listed in Appendix to find matched HEX value.