Cino PL680BT HC - Manual (Page 22)

W
ir
eless FuzzyScan
R
efer
ence Man
ual
Getting Started
14
Batch Scanning (Inventory Mode)
Thanks to the specially designed Batch Scanning function, the scanner is capable of storing the barcode data. It is an ideal
cost-saving solution for inventory applications.
Once you scan the ““Enter Batch Scanning” command to activate this function, all scanned barcode data will be stored into
the memory storage, and the status indicator of scanner will give green blink at regular interval during batch scanning. You
can scan and store the barcode data till the memory storage is full. If the storage is full, you will hear 2 long beeps and the
status indicator will give 2 red blinks to indicate out of storage.
If you use pocket scanner, you can also press and hold the Function Key 2 for more than 3 seconds to enter Batch
Scanning, by which 3 beeps will be heard and the status indicator of the scanner will blink green at regular interval during
batch scanning.
To exit the batch scanning, please scan the “Exit Batch Scanning” command. If you use pocket scanner, you can also exit
the batch scanning by pressing and holding Function Key 2 for more than 3 seconds.
Enter Batch Scanning Exit Batching Scanning
Using Quantity Feature
The scanner supports quantity feature when it enters batch scanning. When you use quantity feature, the quantity
information and scanned barcode data will be stored into the memory storage together. You can enter the quantity
information from 1 to 9999 by scanning the following quantity commands right after you scanned the barcode data.
Quantity 0 Quantity 5
Quantity 3 Quantity 8
Quantity 1 Quantity 6
Quantity 4 Quantity 9
Quantity 2 Quantity 7