Cino PL680BT HC - Manual (Page 98)

W
ir
eless FuzzyScan
R
efer
ence Man
ual
Configure Your FuzzyScan
90
PROGRAM
Condensed DataWizard
♦ Data Organizer Setting ♦
F_DEFAULT
Family Code Selection P.C Parameter Selection Option Code 2nd Option Code
Organizer Control SS
MS
MS
Disable
Select one bar code symbology
Select all bar code symbologies FIN
(2 digits)
00
automatic termination
automatic termination
1st Organization SS
DS Disable
Enable
2-digits identified position;
Forward/backward data transmission setting FIN
(2 digits)
position
direction
0 (Forward)
1 (Backward)
2nd Organization SS
DS Disable
Enable
2-digits identified position;
Forward/backward data transmission setting FIN
(2 digits)
position
direction
0 (Forward)
1 (Backward)
Include/Exclude Control SS
DS Transmitted data excluded the data of identified position
Transmitted data included the data of identified position
0
1
The Data Organizer is used to edit the scanned raw data prior to transmitting the data to the host computers or terminals. It allows you to select desired bar code
symbologies for organizer control, and provides maximum two identified positions to send the data forward or backward. It also allows you to control the transmitted data
including or excluding the data of identification position. Please refer to the application example listed in page 60 for details.
While the Data Organizer is enabled, it arranges only scanned data without Preamble, Postamble, STX, ETX, Data Length, Prefix/Suffix Symbology ID or Record
Suffix.
Regarding the “Bar Code Selection” and “Position Calculation” of Data Organizer, please refer to page 60 for details.
Please note that all “Character” input should be referred to the ASCII/HEX Table.