Cino PL680BT HC - Manual (Page 96)

W
ir
eless FuzzyScan
R
efer
ence Man
ual
Configure Your FuzzyScan
88
PROGRAM
Condensed DataWizard
♦ Data Verifier Setting ♦
F_DEFAULT
Family Code Selection P.C Parameter Selection Option Code 2nd Option Code
Verifier Control SS
MS
MS
Disable
Select one bar code symbology
Select all bar code symbologies FIN
(2 digits)
00
automatic termination
automatic termination
Identified Data Length SS
MS
Disable
Enable
Determine the identified data length for verification. FIN
(2 digits)
1st Identified Character SS
DS Disable
Enable
2-digits checking position; 1 identified character FIN
(2 digits)
position
[00-7F]
2nd Identified Character SS
DS Disable
Enable
2-digits checking position; 1 identified character FIN
(2 digits)
position
[00-7F]
3rd Identified Character SS
DS Disable
Enable
2-digits checking position; 1 identified character FIN
(2 digits)
position
[00-7F]
The Data Verifier is used to provide advanced verification for error-free scanning and to work as an Embedded Data Transmitting Filter.
All data must conform to the Identified Bar Code Symbologies, Identified Data Length, and one to three Identified Characters in the checking position. Otherwise, the
FuzzyScan will not transmit the data to the host computers or terminals, but will instead issue 3 long beeps for verification error and skip the scanned data.
The Data Verifier checks only scanned data without Preamble, Postamble, STX, ETX, Data Length, Prefix/Suffix Symbology ID or Record Suffix.
Regarding the “Bar Code Selection” and “Position Calculation” of Data Verifier, please refer to page 60 for details.
Please note that all “Character” input should be referred to the ASCII/HEX Table listed in Appendix to find matched HEX value.