Cino PL680BT HC - Manual (Page 74)

W
ir
eless FuzzyScan
R
efer
ence Man
ual
Configure Your FuzzyScan
66
PROGRAM
Operation Control
(A Series)
♦ Batch Reading ♦
F_DEFAULT
Family Code Selection P.C Parameter Selection Option Code
Batch Reading
SS None
Batch Reading rule input ( 01-16 rules)
[FIN]
[Rules] [FIN]
Batch Reading: When this function is enabled, you can scan multiple barcodes one by one continuously upon one trigger event. The scanner reports a good read beep and
indication only if all bar codes set by the “Batch Reading Rule” are read. Otherwise, the scanner reports an error beep and indication. The scanned data will be transmitted
according to the preset sequence which is defined in “Batch Reading Rule” regardless the scanned order of those barcodes.
Batch Reading function is only available Trigger Mode.
Batch Reading is not available when Multiple Read Mode or Center Alignment is turned on.
Batch Reading Rule:
- To set the Batch Reading rule
1. Scan the PROGRAM symbol.
2. Scan the Batch Reading symbol (Family Code).
3. Use the Option Code to define the preset Batch Reading rule.
4. Scan the FIN symbol.
5. Scan the END symbol to save your Batch Reading rule.
Note: Scan the ABORT and END symbol to exit without saving any Batch Reading rule setting.
- When you scan “None”, the preset Batch Reading Rule will be cancelled.
- Batch Reading Rule Syntax:
[n] [Element 1] FF [Element 2] FF [Element 3] FF …[Element n] FF
Where n is the number of elements in the overall rule. The number of elements is up to 16.FF indicates the end of one element.
- Element structure:
[Cino ID Hex value] [Code length] [Character match(es)]
Where:
[Cino ID Hex value]
Length: 2 byte
Please find Cino ID hex value from Symbology ID Table in appendix. Locate the Hex value for the symbology and scan the 2 digit hex values from the Option
Code.
Note: 99 is the universal number, indicating all symbologies.